WIX Filters · 57xxx · return line

57416 filter element: specifications & equivalents

Q: What are the dimensions of the 57416 filter element?

The published envelope is 130 mm OD × 277 mm length (5.118 × 10.906 in). Confirm against the housing drawing before ordering.

Q: What micron rating does 57416 use?

This element is rated 8 µm (nominal class). Always compare Beta ratings at the same test point: two brands may print different micron numbers for the same physical grade.

The 57416 is a WIX Filters return-line hydraulic filter element, built with paper media, sized 130 × 277 mm OD × length, rated at 8 µm class. Verify against the current manufacturer data sheet before ordering.

Envelope OD × L 130 × 277 mm

Filtration rating 8 µm nom.

Media Paper

Thread 1-1/2-16

Collapse / burst 22.408 bar

Line type return

Catalog verified. Parameters extracted from the manufacturer’s electronic catalog / official interchange document and checked 2026-09-28. Confidence score 0.90.

Specification table

Parameter	Value
Filter type	return line
Media	Paper
Filtration rating	8 µm
Rating basis	nominal
Outside diameter OD	130 mm
Length	277 mm
Thread / connection	1-1/2-16
End caps	spin-on baseplate with attached gasket
Flow direction	outside-in
Collapse / burst pressure	22.408 bar
Integral bypass valve	none (housing/valve-dependent)
Seal material	Nitrile (NBR)
Manufacturer part no.	57416
Source catalog	WIX Filters (MANN+HUMMEL): WIX Filters online product catalog
Last verified	2026-09-28

Sources: WIX Filters (MANN+HUMMEL) — WIX Filters online product catalog — accessed 2026-09-26.

WIX Filters® and all model designations are trademarks of their respective owners, used here for identification only — ElementRef is an independent reference site, not an authorized WIX Filters distributor.

Dimensional drawing

Reference drawing generated from the source values cited on this page — nominal envelope, schematic section, not a manufacturer drawing. The PDF is A3 landscape and vector; the PNG is sized for a WhatsApp preview. Confirm thread, end caps, seal compound and micron/Beta grade against the original element before ordering.

Dimensions & series range

Outside diameter	130 mm (5.118 in)
Overall length	277 mm (10.906 in)

All 130×277 mm interchange elements →

Cross references & equivalents

Equivalent model	Brand	Match level	Note
↔ HF35477	Fleetguard	partial	Fleetguard's online catalog lists 57416 as an interchange for HF35477. Envelope cross-reference; verify micron grade, collapse rating and seal configuration before substituting.

Interchange levels: full catalog-confirmed drop-in · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

Full chart: WIX Filters cross reference chart →

How the 57416 model number is decoded

57416WIX hydraulic spin-on filter part number.
1-1/2-16Mounting thread: 1-1/2-16 (spin-on baseplate).
PaperFilter media: Paper.

Typical equipment & applications

Mobile and industrial hydraulic return circuits
Construction and agricultural equipment
Heavy-duty transmission and torque-converter circuits

Selection pitfalls — read before you substitute

Line type is not interchangeable: return-line cartridges are low-collapse executions that typically tolerate roughly 10–20 bar differential, while pressure-line elements are commonly rated 100–210 bar. Installing a low-collapse element in a pressure housing can rupture the media on cold-start spikes.
This element has no integral bypass — opening pressure is set by the housing’s reusable bypass valve. Confirm the valve setting (commonly 3.4 bar) is present before fitting.
“10 µm nominal” and “12 µm at β1000” can describe the very same media — one is reported at β≥200, the other at β≥1000 per ISO 16889. Compare ratings at the same Beta test point, not just the printed micron number.
This execution uses nitrile (nbr) seals — verify the compound against the fluid data sheet: standard nitrile (NBR) can fail early in phosphate-ester fluids and at sustained high temperature, where fluorocarbon/Viton executions may be required.
End-cap geometry and the number/position of O-rings block interchange even when OD and length match — visually compare end caps before fitting, especially with aftermarket cartridges.

Frequently asked questions

What are the dimensions of the 57416 filter element?

The published envelope is 130 mm OD × 277 mm length (5.118 × 10.906 in). Confirm against the housing drawing before ordering.

What micron rating does 57416 use?

This element is rated 8 µm (nominal class). Always compare Beta ratings at the same test point: two brands may print different micron numbers for the same physical grade.

What replaces the 57416 filter element?

1 partial match(es) requiring parameter review

How do I read the 57416 part number?

See the designation decoder above: each segment of 57416 encodes size, line type, filtration grade and media/collapse execution.

Is a same-envelope aftermarket element always a drop-in replacement?

No. Matching OD and length only proves the cartridge fits the bowl. End-cap style, seal compound, micron/Beta rating, collapse pressure and bypass configuration must also match; the table above tags every equivalent as full, partial or verify for exactly this reason.

How often should a hydraulic filter element be replaced?

Replace at the housing manufacturer’s recommended differential-pressure setting (commonly signalled by a clogging indicator), or on a time-based service interval when no indicator is fitted — never wait for bypass to open continuously, because unfiltered oil then reaches the valves.

Same-envelope elements from other brands

View full interchange →

These 1 catalog element(s) share the 130×277 mm envelope. Envelope match alone does not guarantee interchangeability — compare micron/Beta, seals and collapse rating.

57608 WIX Filters · 141 µm

Other models in the 57xxx series

All 221 →

57000 78×80 mm · 21 µm 57002 68×69 mm · 15 µm 57005 60×229 mm 57023 76×87 mm · 32 µm 57024 52×150 mm · 9 µm 57030 64×99 mm · 35 µm 57031 88×140 mm 57039 94×142 mm · 25 µm 57043 97×234 mm · 3 µm 57044 119×227 mm · 17 µm

Reviewed & verified by the ElementRef engineering desk against WIX Filters (MANN+HUMMEL) on 2026-09-28. Read our editorial & correction policy.