MANN-FILTER · HD / WD Hydraulic · inline line
HD882/6 filter element: specifications & equivalents
The HD882/6 is a MANN-FILTER inline-line hydraulic filter element. Verify against the current manufacturer data sheet before ordering.
Dimensions and comparison numbers are taken from the MANN-FILTER online catalog API. Beta rating, collapse pressure and seal material vary by execution — verify against the current MANN data sheet before ordering.
Specification table
| Parameter | Value |
|---|---|
| Filter type | inline line |
| Outside diameter OD | 80 mm |
| Inside diameter ID | 44 mm |
| End caps | open-ended cartridge element |
| Integral bypass valve | none (housing/valve-dependent) |
| Manufacturer part no. | HD882/6_MANN-FILTER |
| Source catalog | MANN+HUMMEL / MANN-FILTER: MANN-FILTER online product catalog GraphQL API (mann-filter.com, store pcat_mf_en_store_en) |
| Last verified | 2026-09-28 |
Sources: MANN+HUMMEL / MANN-FILTER — MANN-FILTER online product catalog GraphQL API (mann-filter.com, store pcat_mf_en_store_en) — accessed 2026-09-27.
MANN-FILTER® and all model designations are trademarks of their respective owners, used here for identification only — ElementRef is an independent reference site, not an authorized MANN-FILTER distributor.
Dimensions & series range
| Outside diameter | 80 mm (3.150 in) |
| Inside diameter | 44 mm (1.732 in) |
Cross references & equivalents
| Equivalent model | Brand | Match level | Note |
|---|---|---|---|
| ↔ SP-130-E-03-B-OBE | STAUFF | partial | STAUFF Filter Interchange lists HD 882/6 (MANN-Filter) as replaced by SP-130-E-03-B-OBE. Envelope dimensions are published; media grade and performance data are not — confirm before substituting in cleanliness-critical circuits. |
Interchange levels: full catalog-confirmed drop-in · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.
How the HD882/6 model number is decoded
- HD882/6MANN-FILTER hydraulic cartridge element part number.
- 80 mmOuter diameter (A).
- 44 mmInner diameter (B).
Typical equipment & applications
- Replacement element for OEM hydraulic filter housings
Selection pitfalls — read before you substitute
- “10 µm nominal” and “12 µm at β1000” can describe the very same media — one is reported at β≥200, the other at β≥1000 per ISO 16889. Compare ratings at the same Beta test point, not just the printed micron number.
- Nitrile (NBR) seals are standard for mineral hydraulic oil but fail early in some phosphate-ester fluids and at sustained high temperature; verify seal compound against the fluid data sheet (fluorocarbon/Viton executions may be required).
- End-cap geometry and the number/position of O-rings block interchange even when OD and length match — visually compare end caps before fitting, especially with aftermarket cartridges.
Frequently asked questions
What replaces the HD882/6 filter element?
How do I read the HD882/6 part number?
Is a same-envelope aftermarket element always a drop-in replacement?
How often should a hydraulic return-line element be replaced?
Other models in the HD / WD Hydraulic series
All 880 →Reviewed & verified by the ElementRef engineering desk against MANN+HUMMEL / MANN-FILTER on 2026-09-28. Read our editorial & correction policy.